Most balsa suppliers purposely cut the lightest raw balsa into blocks, and the hardest raw balsa into sticks. We import balsa wood from Ecuador and control the quality strictly, so our balsa wood is of superior quality in 3A rank. All tip submissions are carefully reviewed before being published, This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness. Tip: Try to make the first pass for your cuts no deeper than 1⁄32 in (0.079 cm). Vary the length of the sticks a little if you like; 50-60mm for smaller baitfish, 60-80mm for larger baits. This image is not<\/b> licensed under the Creative Commons license applied to text content and some other images posted to the wikiHow website. If I were using a new piece of wood I would pack the outlines really tightly to use the wood as efficiently as possible. Apply very light pressure to the knife. Theoretically the part should be cut on the inside of the line, but if you try to do that you will inevitably cut it too small in one or more spots. $44.95 $ 44. 5 Here, the two longerons are ready to be glued together. Sheets are cut in the entire wide range of density. Balsa wood sticks can be used for towers, bridges, structures, craft projects, RC airplanes, and models. Some kits require you to cut balsa sticks at precise lengths and angles to create truss structures. A medium rough sand paper (a 60 to 80 grit). There are 10 references cited in this article, which can be found at the bottom of the page. % of people told us that this article helped them. Cut a multi purpose adhesive sheet and scrap of dsp to 7x7cms and stick the dsp to the balsa wood. Tip: Balsa wood that is 1⁄8–1⁄4 in (0.32–0.64 cm) thick is a good thickness to start with if you are new to cutting balsa wood. Only use a pen if you are very sure of yourself! This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness. Keep the blade perpendicular to the card surface to achieve an even, un-slanted edge. When not in use remove the scalpel. Balsa Wood Sticks SYN-013 - Synhong Products Made In China, China Manufacturer. A sanding block makes a good tool for pushing the balsa along and a wooden push stick for finishing the cut, both of which will keep your fingers away from the blade. Balsa wood Uses. {"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/3\/3d\/Cut-Balsa-Wood-Step-1-Version-2.jpg\/v4-460px-Cut-Balsa-Wood-Step-1-Version-2.jpg","bigUrl":"\/images\/thumb\/3\/3d\/Cut-Balsa-Wood-Step-1-Version-2.jpg\/aid11125996-v4-728px-Cut-Balsa-Wood-Step-1-Version-2.jpg","smallWidth":460,"smallHeight":345,"bigWidth":"728","bigHeight":"546","licensing":"